For example, you can configure one camera and two radios as follows: For a router with IP address of 192.168.1.1, you only have to change the fourth octet in the default ip address, that is 192.168.1.XXX where XXX is the set of numbers that need to be changed and must be unique for each device on the network. The AP and the Station radios both have the same default IP address before being configured, and will have to have a different IP address to be connected to the network at the same time. It is important to note that the default IP address for the AP and our ip cameras are as noted below.: In our network, the router address is 192.168.1.1 and our computer IP address is 192.168.1.4. The IP address of the computer you are using will be listed under IPv4 Address, and the Router IP will be listed as the Default Gateway.
Axis camera station background service not running windows#
Type ipconfig in the windows command prompt and press Enter.Ģ) Locate your computer IP address and router IP address in the output from the ipconfig command. Click on the Start button on your windows computerĪ command prompt like the following will appear.Step 1: Determine your computer IP address Let's begin with the setup of configuring one IP Security Camera to wire into the Station and send the signal back to the 2.4GHz Wireless Outdoor Access Point. Once you have your cameras streaming back to your security video recorder, you can even do port forwarding and make your camera or NVR accessible for remote viewing from the outside world. If you use our Tribrid DVR you can even connect other types of cameras that use coax cabling and use wired IP cameras, wireless IP cameras, analog CCTV cameras, and HDCVI HD over coax cameras. Using IP cameras makes it easy to make any type of camera wireless and tie it back to the same recorder where other wired or wireless ip cameras are connected. The NVR records the IP camera streams it is receiving to a hard drive inside, and makes the cameras accessible for viewing from remote users.The router then routes the data to your NVR (also supplies internet to the NVR).The AP (Access Point) converts the data received over WiFi in to a wired network signal and sends it to your router.The Station AP transfers that data in to a WiFi signal and beams it to the AP at the NVR location.The camera sends data over a network cable (through a switch if there are multiple cameras attached) to the Station AP.Let's break it down in to layman terms how the signal gets from the camera to the NVR Connecting to multiple cameras using a switch We don't recommend using more than 4 cameras per AP, otherwise you will clog your wireless connection with more data than it can handle. We connect the Access Point to our router or switch to which the NVR is also connected.Īt the Station AP, we can connect one camera directly to the radio, or mutliple cameras to the radio by using a switch in between. Connecting a IP Camera System to Access PointsĪt the Access Point Side, our setup is geared toward making it possible for the NVR recorder to communicate wirelessly to the cameras located on the Station AP. Once the two radios are talking to each other, you have a PTP (Point to Point) wireless link. The other radio is configured as a Station AP that acts as a receiver station or client on the wireless network. One radio is configured as the Access Point, which sends the WiFi signal that is discoverable as a SSID or available wireless network. Each of these units has a WiFi radio and a high gain antenna which makes these units powerful enough for a mile or more of line of sight wireless transmission. Although in our case we are using 2.4GHz models, this setup can be done with 5.8GHz models as well. We will use two wireless access points to connect to each other to create a point-to-point WiFi connection. It is important to understand how all this works. Up to 600ft Range (clear line of sight) when used with WiFi cameras with integrated radio.Great for indoor applications where space is limited.
0 kommentar(er)
